SprayMax SoyThane Urethane Foam, more then just an Insulation
Spraying Foam Roof with FastKick Spray Gun Proportioner
(1888PressRelease) July 21, 2008 - SoyThane, a spray in place urethane foam insulation has long been considered just wall insulation foam. The introduction of SoyThanelll has changed this.
SoyThanelll is a 3 pound spray urethane foam used for both Urethane Foam Roofing and Urethane Foam Roof Repairs.
Shindler Roofing http://www.schindlerroofing.com/, owner Andy Schindler recently displayed the versatility of SprayMax Industrial Coatings Inc’s Soythane and MaxLiner Polyurea on a unique Condominium roof in Utah.
Schindler Roofing was faced with repairs on a 10 Story High Rise Condominium. The present Urethane Foam Roof was 30 years old. Over the 30 year span some minor defects had occurred under the AC units. Concrete slabs to the Penthouse were also in need of a waterproof membrane. The problem was access to the roof was hard and to elevate heavy high pressure equipment nearly impossible.
Andy Schindler had purchased a FastKick Gun by SprayMax Industrial Coatings Inc a year previous and contacted SprayMax to see if it was feasible to use on this job.
After reviewing the job SprayMax informed Andy that the FastKick Gun, SoyThanelll and Polyurea were the perfect answer.
The FastKick Gun sprays Multi Component materials by SprayMax with the simple use of an Air Compressor, no electricity is needed. This unique Spray Gun proportioner works by a small air motor simply pushing both the A side and B side factory prefilled cartridges through a static mixer that Air atomizes the instant cure materials.
Roof side Andy cut out the bad foam areas inserted the SoyThane 3 Lb foam roofing cartridge and sprayed new expanding foam. After the spray Andy simply threw the empty cartridges away as they are VOC free.
Next, after preparing the concrete decks, Andy simply changed cartridges to the MaxLiner Polyurea instant set membrane in Desert sand color. It was like applying a rubberized Bed liner to the concrete deck Andy said.
Tom Hay, COO of SprayMax Industrial Coatings Inc was quoted as saying “This type application shows the beauty and ease of application for our system. No mess, easy to get to even the hardest areas and the ability to change materials with no clean up or down time. A novice can become an expert at spraying multi component instant set materials as long as they know proper preparation of substrates.
To learn more of this remarkable system visit http://soythane.com/ or call Tom Hay at 1-877-772-9629.
SprayMax SoyThane Urethane Foam, more then just an Insulation 
Spraying Foam Roof with FastKick Spray Gun Proportioner
Satisfied Users & 
Approved Press Releases
Print
Email
Report Spam